The Utilitys stem, as with the Squirt, Zip, and I assume several other Glen-L designs, is made of 2 laminations of 3/4 plywood. Fortunately, I had enough 3/4 marine-grade Douglas Fir plywood left over from Lusitania 13s second transom to build both the transom and the stem for the Utility. The laminations are glued together with marine epoxy, (I used Poxy-Shield thickened with #2 silica), and bronze screws. The breasthook is basically made the same way, although the mating pieces are shaped differently: The top piece fits over the stem, and the bottom supporting piece fits around the stem. The breasthook is then epoxied onto the stem. I clearly marked all my centerlines, and tried to make the pieces fit as precisely as possible.
With the centerline on the keel clearly marked, I clamped the Utilitys stem/breasthook assembly into position. Next, using twine and a plumb bob, I worked carefully to make sure the whole assembly was aligned with the centerline of the keel. As a one-person job, this is rather tricky. If you have someone to help, it should be much easier.
With the assembly clamped into position, I drilled two 1/4 holes vertically through the forward part of the keel and aft section of the stem, countersinking the carriage bolts. After applying copious amounts of thickened epoxy, I bolted the stem to the keel with 5 long, 1/4 bronze carriage bolts. After tightening them, I filled the extra space from the countersunk carriage bolts with thickened epoxy.
Stem clamped and bolted onto forward end of keel.
Stem-to-keel joint after epoxy. Glue blocks added for reinforcement.
Having now learned my lesson from having to build up the keel thickness, I turned to the floor battens. As I mentioned before, the frame notches for these were cut to 1 deep. 1-inch lumber off-the-shelf is typically only 3/4 thick. So, for the floor battens, I purchased an 8-foot, 5/4 mahogany board. (After they plane 1/4 off it at the lumber yard, youre left with an actual 1-inch thick board.) The cuts for the floor battens were straight cuts, producing four 2 wide battens. Cutting the battens produces a lot, I mean a lot, of red sawdust. I decided to sweep up & collect most of it to use as wood flour to thicken epoxy later on. This turned out to work quite well.
The floor battens had to be fitted into the transom frame notches the same as the keel. The battens were fastened on with thickened epoxy and 2 bronze screws.
Transom knees attached to keel & transom. I put these on before adding the floor battens.
A note about bronze screws
Bronze screw heads are rather soft, and will strip out on you easily. This is particularly true when using a power drill as a screwdriver. Below is the method I used to remove a stripped screw during the fitting process for the floor battens:
Totally stripped-out bronze screw head.
I cut a slot in it with my Dremel.
Removal was then easy with a flat-head screwdriver.
0 komentar:
Posting Komentar